The specimens were manufactured and maintained according to the GB/T 50, standard. HJW60 mixer was used to mix cement, coal gangue powder, tailings powder, and coal gangue manufactured sand for 2 min, and then water was added to stir for 2 min. After mixing evenly, the material was discharged.
WhatsApp: +86 18203695377
At the Second CoalOil Mixtures Conference, in Danvers, MA, 1979, it was proposed, possibly seriously for the first time, that coaloil slurries should be produced by wet grinding of the coal in oil rather than dry grinding followed by mixing the powder into the oil. Blending powdered coal into fuel oil, typically bunker oil, was, indeed ...
WhatsApp: +86 18203695377
In view of the disadvantage that coal waste powder(CWP) can reduce the crack resistance of asphalt mortar at low temperature, silane coupling agent KH550 was used to modify coal waste powder. The surface characteristics and modification mechanism of silane coupling agent modified coal waste powder were characterized by using Scanning Electronic Microscopy (SEM). Five kinds of silane coupling ...
WhatsApp: +86 18203695377
Performance of fiber reinforced asphalt concrete under environmental temperature and water effects. Constr. Build. Mater. (2010) T. Xu et al. ... Effect of coal waste powder in hot mix asphalt compared to conventional fillers: mix mechanical properties and environmental impacts. Journal of Cleaner Production, Volume 91, 2015, pp. 262268 ...
WhatsApp: +86 18203695377
The pulping steps were as follows [22]: (1) measure out the weights of coal powder, additives, and liquids (deionized water and waste oil) required to make up the slurry; (2) pour the additives and liquids into a stirring tank with a capacity of 200 mL and adjust the speed of the mixer to 400500 r/min to fully dissolve the additives; (3) add ...
WhatsApp: +86 18203695377
INTRODUCTION. Coal water slurry (CWS) is a fuel which consists of fine coal particle suspended in water. Presence of water in CWS reduces harmful emissions and makes the coal explosion proof thus makes it useful as a liquid fuel. The concept of coal water slurry dates back to Smith and Munsell (1879) [1] when patented for coal oil utilization ...
WhatsApp: +86 18203695377
A coalwater slurry fuel is defined by a number of factors including its viscosity, particle size, rate of sedimentation, ignition temperature (800850 °C [1,4701,560 °F]), combustion temperature (9501,150 °C [1,7402,100 °F]), ash content and calorific value ( kcal/kg ). When coalwater slurry fuel combusts, over ...
WhatsApp: +86 18203695377
The pitch was pretreated using nitric acid (HNO 3) and a thermal treatment step; this process increased the softening point of the pitch which improves the ing properties [6] and allows better physical mixing of the pitch with the coal powder. We investigated the effect of pitch pretreatment conditions on the final carbon properties by ...
WhatsApp: +86 18203695377
The effect of addition sequence for mixed collectors comprising of dodecane(D) and nvaleric acid(A) on lowrank coal flotation was explored by the following three sequences: D first and then A(D + A), A first and then D(A + D), D and A were added simultaneously(M). The total organic carbon, contact angle, zeta potential, and Xray photoelectron spectroscopy results revealed that the coal had ...
WhatsApp: +86 18203695377
Coal flotation is a complex process involving several phases (particles, oil droplets and air bubbles). These phases simultaneously interact with each other and with other species such as the molecules of a promoting reagent and dissolved ions in water. The physical and chemical interactions determine the outcome of the flotation process.
WhatsApp: +86 18203695377
Of the different additives, the viscosity reduction effect of Tween 80 in the waste oilcoalwater slurry was best. Further, the comprehensive performance of the waste oilcoalwater slurry, including slurry ability, stability and fluidity, was found to be best at a water content of 10% and a Tween 80 content of 5%.
WhatsApp: +86 18203695377
Fu et al. [16] and Zhu et al. [17] studied the effects of light oil, fine coal powder, and water content as well as the properties of surfactants on the rheology and stability of synthetic fuels. Guo et al. [18] studied the rheological properties of a new type of synthetic fuel composed of residual oil, coal powder, and water.
WhatsApp: +86 18203695377
Coal powder was placed in a xanthan gum solution having concentration identical to that of the WCWS. The adsorbed suspension was subjected to highspeed centrifugation to separate the wet coal powder. The coal powder was dried in an oven at 60 °C, and pressurized and polished into a tablet with a thickness of mm and diameter of 2 cm.
WhatsApp: +86 18203695377
Moreover, Yi et al. [6] used bio oil from biomass pyrolysis to prepare coal water slurry to confirm that the coal water slurry changed from weak to strong pseudoplastic fluid with the increase in the water content of bio oil. Zhang et al. [7] prepared coal water slurry by using waste engine oil and proposed that the possible stabilization ...
WhatsApp: +86 18203695377
The pulping steps were as follows [22]: (1) measure out the weights of coal powder, additives, and liquids (deionized water and waste oil) required to make up the slurry; (2) pour the additives and liquids into a stirring tank with a capacity of 200 mL and adjust the speed of the mixer to 400500 r/min to fully dissolve the additives; (3) add ...
WhatsApp: +86 18203695377
Fly ash is a fine powder recovered from gases created by the burning of coal. It is the largest component of coal combustion waste, totaling around 70 million tons annually in the United States ...
WhatsApp: +86 18203695377
Results show that the addition of sludge can improve the static stability for slurries prepared by lean coal, coking coal, and lignite. The effect on stability of coking coalwater slurry is the most significant. The proportion of sludge to lean coal added in the slurry can be maintained at 10% to 15%.
WhatsApp: +86 18203695377
DOI: / Corpus ID: ; Synergistic effects of mixing waste activated carbon and coal in coslurrying and CO2 cogasification article{Wang2021SynergisticEO, title={Synergistic effects of mixing waste activated carbon and coal in coslurrying and CO2 cogasification}, author={Jianbin Wang and Jian Chen and Jianzhong Liu and He Liu and Mingxia Wang and Jun Cheng ...
WhatsApp: +86 18203695377
1. Introduction. In China, lowrank coal (LRC) is an important part of thermal coal and coal for the coal chemical industry. With the improvement of coal mining and coal preparation mechanization, LRC is prone to produce a large amount of slime in coal mining and processing due to its porous and fragile characteristics [[1], [2], [3]].These finegrained coal slimes have low calorific value and ...
WhatsApp: +86 18203695377
Adhesion forces for water/oil droplet and bubble on coking coal surfaces with different roughness. ... Surface properties of aged coal and their effects on bubbleparticle attachment during flotation. Adv Powder Technol, 31 (4) ... Effect of microemulsion on lowrank coal flotation by mixing DTAB and diesel oil. Fuel, 260 (2020), p. 116321.
WhatsApp: +86 18203695377
Further, the comprehensive performance of the waste oilcoalwater slurry, including slurry ability, stability and fluidity, was found to be best at a water content of 10% and a Tween 80 content ...
WhatsApp: +86 18203695377
2) A specific mass of water is poured into a mixing tank, and the speed of the electric mixer (JHS2) is adjusted to 200 r/min, after which additives are added and fully dissolved in the water. 3) The weighed coal powder is added to the mixing tank, and the speed of the mixer is raised to 1000 r/min and kept there for 15 min. 4) The slurry is ...
WhatsApp: +86 18203695377
void fraction of the coal powder beds is the porosity of particle bed when the voids of coal particle bed are filled with water. Void fraction of CWS was calculated by the following equation (Henterson,, 1978). ε = V. s V. c (2) V. s. where ε, V. c, V. s . referred to as void fraction, volume of coal, and volume of slurry ...
WhatsApp: +86 18203695377
Abstract. Coaloilwater slurry (COWS) synfuel can be prepared successfully by waste engine oil (WEO), water and coal in the existence of Tween 80 and SL. The effects of coal type, coal particle size distribution, and WEO blending proportion (α) on the slurryability of COWS were investigated, and certain essential properties, such as ...
WhatsApp: +86 18203695377
This invention relates to a mixed fuel comprising a coal powder or the like and heavy oil obtained by adding and mixing a dilute aqueous solution of a watersoluble highmolecular compound and a carbonaceous solid fuel powder such as coal powder or the like (hereinafter referred to as "coal powder and the like") to heavy oil so as to disperse the coal powder and the like and water (in very ...
WhatsApp: +86 18203695377
Activated charcoal is thought to offer several other benefits, including less gas and flatulence, lower cholesterol levels, and improved kidney function. Some people claim that it helps whiten ...
WhatsApp: +86 18203695377
The attraction of the coalwater slurry is its complete independence of an oil supply; coaloil mixtures are effectively a means of extending oil supplies and are less economically beneficial. Coalwater slurry is simply produced by mixing pulverised coal with water together with a small amount of a surfactant and a stabilizing agent.
WhatsApp: +86 18203695377
Consequently combustion equipment has to be derated. An attempt to overcome this has involved emulsifying water with coaloil mixtures (40 wt % coal, 40 wt % oil, 10 wt % water) with the intention of causing disruptive combustion. ... A 50:50 blend (or 1:1 blend) includes 50% of the volume of the powder as fly ash and 50% of the volume of ...
WhatsApp: +86 18203695377
Herein, a method of mixed combustion of meager coal and SCCB in a pulverized coal furnace for disposal of SCCB is proposed, and thermogravimetric mass spectrometry (TGMS) is used to characterize the combustion and gas release characteristics. The effects of the heating rate and mixing ratio on combustion are analyzed as well.
WhatsApp: +86 18203695377
Abstract. The main objective of this research was to investigate the effect of coal waste powder as filler material in hot mix asphalt. After sampling the coal waste material from a coal washing plant, it was processed to achieve natural coal waste filler. Furthermore, after incinerating the natural coal waste powder at 750 °C, the coal waste ...
WhatsApp: +86 18203695377
A material supplier from Belgium would like to produce limestone powder for his custome...
India is rich in various mineral resources and it is an important mineral processing market
Copyright © 2023 GMC Co., Ltd. SiteMap
